Publicité
2
Push the brake line into the clamping piece set up to the
illustrated line.
3
Hand-tighten both clamping screws.
4
To determine the correct clearance of the line, screw the
spacing screw in up to the limit stop in the
clamping piece set.
5
Tighten both clamping screws.
6
Remove the spacing screw
7
Select the flaring adapter that matches your clamping set.
8
Please grease the thread on the adapter
to prevent damages.
D I N F L A R I N G
•
Screw in the DIN crimping adapter up to the limit stop and
then remove it.
•
Completely loosen both clamping screws and remove the line
from the clamping pieces.
S A E F L A R I N G
•
Pay attention to the arrow attached to the flaring adapter.
•
Screw in the SAE flaring adapter, first in the direction of the
arrow up to the limit stop and then remove it.
•
Turn the adapter in opposite to the direction of the arrow into
the clamping piece up to the limit stop.
•
Completely loosen both clamping screws and remove the line
from the clamping pieces.
6
M O D E D ´ E M P L O I
A P P A R E I L Á C O L L E T S M É C A N I Q U E , P O U R S A E E T D I N
2 4 5 2 9 L
Publicité
