Electrolux LXB3AE82R Notice D'utilisation page 32

7. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem
The appliance does not operate.
The appliance is noisy.
The compressor operates continual‐
ly.
Door is misaligned or interferes with
ventilation grill.
Door does not open easily.
The lamp does not work.
There is too much frost and ice.
Water flows on the rear plate of the
refrigerator.
32 ENGLISH
Possible cause
The appliance is switched off.
The mains plug is not connected to
the mains socket correctly.
There is no voltage in the mains
socket.
The appliance is not supported
properly.
Temperature is set incorrectly.
Too much food is put in at the same
time.
The room temperature is too high.
Food placed in the appliance is too
warm.
The door is not closed correctly.
The appliance is not levelled.
You attempted to re-open the door
immediately after closing.
The lamp is defective.
The door is not closed correctly.
The gasket is deformed or dirty.
Food is not wrapped properly.
Temperature is set incorrectly.
Appliance is fully loaded and is set
to the lowest temperature.
Temperature set in the appliance is
too low and the ambient tempera‐
ture is too high.
During the automatic defrosting
process, frost melts on the rear
plate.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical appli‐
ance to the mains socket. Contact a
qualified electrician.
Check if the appliance stands sta‐
ble.
Refer to "Control panel" chapter.
Wait a few hours and then check the
temperature again.
Refer to "Installation" chapter.
Allow food to cool to room tempera‐
ture before storing.
Refer to "Closing the door" section.
Refer to installation instructions.
Wait a few seconds between closing
and re-opening of the door.
Refer to "Replacing the lamp" sec‐
tion.
Refer to "Closing the door" section.
Refer to "Closing the door" section.
Wrap the food properly.
Refer to "Control panel" chapter.
Set a higher temperature. Refer to
"Control panel" chapter.
Set a higher temperature. Refer to
"Control panel" chapter.
This is correct.