Publicité
ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures to be
implemented for installation and start-up. Therefore, the installer as well as the user must read the instructions before
beginning installation and start-up.
Keep this manual for future reference.
To achieve optimum performance of the LumiPlus Essential Projectors follow the instructions provided below:
1. VERIFY THE CONTENTS OF THE PACKING:
The following accessories are included inside the box:
PROJECTOR:
70870, 75434, 75776,
75435, 75777, 75778
Projector unit
Lamp
(1) For projectors with metric pitch housing
(2) For projectors with self-threadind housing
2. GENERAL CHARACTERISTICS:
This projector has been designed to be used fully submerged underwater in fresh water swimming pools. It is a Class III
electric apparatus with very low safety voltage (12V with alternating current).
The projector compiles with IPX8 degree of protection (resistance to penetration of dust, solid bodies and humidity) at a
nominal immersion depth of 2 m.
This projector compiles with international safety standards for lights, especially the EN 60598-2-18 standard. LIGHTS PART 2:
SPECIFIC REQUIREMENTS SECTION 18 LIGHTS FOR SWIMMING POOLS AND SIMILAR APPLICATIONS.
The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric components
which have been inserted or handled at locations other than its own premises.
3. INSTALLATION:
• Never install in vertical position with the lamp facing downwards.
• In order to clearly light a pool it is recommended lo install a projector every 20 or 25 m² of water surface.
• In order to prevent glare, the projectors should be installed so that they face away from the residence or usual view of the
swimming pool.
• In the event that lighting is used in training or competition pools, the projectors should be installed on the sides to prevent
glare on the swimmers.
• To avoid the need to empty the pool to change the lamp, we recommend that the projector be installed in areas which are
accessible from the upper edge of the pool.
Prior to installation verify that the gland seal (nº 8) has been fully tightened.
The projector should be placed on the wall of the pool at approximately 400-700 mm from the water surface (Fig.1).
The method of fastening the housing to the pool wall varies depending on whether it is a projector for concrete pools or
prefabricated pools.
Concrete swimming pool
To install a projector in a concrete swimming pool the housing (nº 10) should be fixed in the wall of the swimming pool (Fig.
2). Make sure that the cable outlet of the housing remains on the upper part.
CONCRETE POOL
PROJECTOR: 66828,
74558, 75780, 75437,
75781, 75782
Projector unit
Lamp
Housing body
PREFABRICATED POOL
PROJECTOR:
70528, 75439, 75783, 75440,
75784, 75785
Projector unit
Lamp
Housing body
Watertight joint
Clamp
Bag of screws:
2 DIN 7981 4,8x16 screws
16 DIN 966 M-6x24 screws (1)
16 DIN 7982 5,5x25 screws (2)
2
CONCRETE POOL +LINER
PROJECTOR:
77065, 77065WW, 77066, 77067,
77068
Projector unit
Lamp
Housing body
Watertight joint
Clamp
Bag of screws:
2 DIN 7981 4,8x16 screws
16 DIN 966 M-6x24 screws (1)
Publicité
