Humidifying Tray - Sharp KC-840E Manuel D'utilisation

HUMIDIFYING TRAY

Care Cycle
1 month
1
Remove the Water Tank and Humidifying
Tray.
Unlatch the Water
Tank first, then re-
move the tray. Use
b o t h h a n d s w h e n
pulling out the Hu-
m i d i f y i n g Tr a y t o
avoid spilling water.
2
Remove the Humidifying Filter from the
Humidifying Tray. Drain accumulated wa-
ter by tilting the Humidifying Tray slowly.
Humidifying Filter
3
Rinse the inside of the Humidifying
Tray with lukewarm water to remove
impurities.
• Do not remove the
Styrofoam float.
• Clean difficult-to-
reach parts with a
cotton-tipped swab
or tooth brush.
4
Replace the Humidifying Filter and re-
place the Humidifying Tray in the unit.
The Humidifying Filter will not
fit if placed in backwards. Be
sure there is no gap between
the Humidifying tray and the
unit when the Humidifying Tray
is replaced in the unit. The unit
may not operate properly if the
Humidifying Tray is not prop-
erly replaced in the unit.
If the Styrofoam float comes off,
replace by inserting the tabs of
the Float into the holes in the
Humidifying Tray as shown in the
diagram.
Frequency of maintenance cycle will depend on the hardness
of the water. Avoid spilling water when removing or cleaning
the tray.
Tank Handle
Water Tank
Do not hold
this part.
H u m i d i f y i n g
Tray
Float
Colour: Gray
Insert the tab of the
float into the hole.
E-3
When Water Deposits are Difficult to Remove
1
Fill Humidifying Tray half-
way with lukewarm water,
add a small amount of mild
kitchen detergent, and leave
to soak for about 30 min-
utes.
Dilute detergent according to
instructions on the container.
Clean difficult-to-reach parts
with a cotton
swab or tooth
brush.
2
Rinse the Humidifying
Tray with lukewarm wa-
ter.
• Rinse until all detergent residue
is removed.
• Inadequate rinsing may
cause the de-
tergent odour
or changes
in the shape/
colour of the
main unit.
CAUTION
• Use only mild kitchen detergents to
clean the Humidifying Tray. Use of
non-designated chemicals or deter-
gents can cause deformation, tar-
nishing, cracking (water leakage).
Insert the float below
this tab.
I n s e r t t h e t a b o n
the other side of the
float into the hole.