Publicité
EN
6.3.3
Spreading
WARNING
Prevent sharp objects from touching the plungers.
If a grip head, cutting peak or wedge piece is being used, never apply too much force;
otherwise the accessory will disappear through the opening created and the plunger can be
damaged.
CAUTION
Never use more than one extension pipe at the same time.
Always use a grip head or other accessory on the other end of the extension pipe.
Avoid a crooked load with its risk of sliding off.
Watch out for the danger of being trapped when the plungers are retracted between cylinder
and accessory.
•
Make sure that a grip head or other desired accessory is attached correctly at the end of the
plunger(s) and fixed side.
•
Place the ram between the parts that must be spread.
•
Force the parts apart by opening the plunger(s).
6.3.4
Environmental information
•
Under normal use, no leakage will occur. Therefore, there will be no contact with toxical substances
inside the battery pack.
•
Under normal use, no environmental hazard is present.
6.4
After use
6.4.1
Inspection
•
Check the battery level. Recharge the battery pack, if necessary. See section 3.5.
•
Check the tool for completeness, leaks and damage. Do not use the tool if it leaks or is damaged
and contact the Holmatro dealer.
•
Check the plunger(s) for damage.
•
Check the operation of the deadman's handle. The handle must return to the neutral position when
you release it.
•
Check that the carrying handle is firmly attached.
•
Make sure the ram heads are attached.
•
Check the accessories used for completeness and damage. Replace them if the damage is
considerable.
•
Check the operation of the connection system for the accessories. If it is in poor condition, have it
repaired by the Holmatro dealer.
6.4.2
Shut down
•
Retract the plunger(s) and then open them ± 5 mm, so that the tool can be stored without pressure.
•
Switch the tool off.
•
Remove the battery pack and place it in the battery charger.
46
All manuals and user guides at all-guides.com
916.400.015_003
GTR 53* LP EVO 3
Publicité
