Publicité
EN
5.8.2
The battery for the laser beam must be replaced when the laser beam does not operate when the
switch is pressed. Refer to Fig. 8.
•
Remove the screw (B).
•
Remove the grip head.
•
Replace the battery in the battery holder (A)
NOTICE
Battery type: CR1/3N 3V 170 mAh lithium battery
5.9
Cam and steel ball connection system
Refer to Fig. 7.
The steel ball (C) in the groove (E) and the cam (A) serve to hold the accessory in place.
5.9.1
To attach
•
Position the cam (A) of the accessory (F) in front of the recess (D).
•
Push the accessory firmly on to the ram jack (B) until the steel ball (C) clicks in the groove (E).
•
Turn the accessory 180° with respect to the ram jack so that the recess provides extra locking.
5.9.2
To remove
•
Remove the accessory (F) from the ram jack (B) by turning it around while pulling it at the same
time. When the cam comes to the recess (D) the accessory is released.
6
Use
6.1
General
The equipment of a rescue system must always be ready for use. That means the equipment must be
checked and inspected directly after use, before it is put away.
WARNING
Make sure you are up to date on all safety regulations and that you have mastered the use of
all equipment of the system you are going to work with.
6.2
Before use
•
Before use, always check the State Of Charge of the battery pack. See section 3.5.
44
All manuals and user guides at all-guides.com
916.400.015_003
GTR 53* LP EVO 3
Publicité
