Publicité
3. When cleaning with a disinfectant, be sure to use it after diluting it at the specified concentration.
Depending on the composition of the disinfectant, it may corrode metal parts, resin parts, etc,
causing discoloration, deformation and other undesirable consequences. Therefore, the
recommended content of the disinfectant is as follows:
Do not use a smoking sterilizer or autoclave, and do not use methyl phenol to clean the head foot
board, bed feet, etc, which may cause corrosion, discoloration, deterioration.
Note:
1.
Unplug power cable before cleaning and maintenance
2.
During the cleaning, DO NOT splash water to prevent short circuit and electric shock
3.
When cleaning the bed or changing bedding, pay attention to the corners, edges and screw
parts of the frame to prevent scratches.
7. Mattress maintenance
1.
Avoid scratching the fabric with sharp-angled appliances or knives when using it, cover it with
sheets or cleaning pads, and clean it frequently to keep it clean and dry.
2.
Regularly clean the mattress cover with a vacuum cleaner, it can be washed directly with water
or detergent.
3.
Air the mattress often to keep your sleep fresh and comfortable, but be careful not to expose
the mattress to the sun for too long.
4.
If the fabric is accidentally stained, please refer to the corresponding recommended cleaning
method in the instructions. Do not use corrosive chemicals to clean the fabric.
5.
If you accidentally get chewing gum or other glue-like objects on the fabric, do not wipe it
forcibly. You can use am ice pack to allow it to harden and then peel it off gently.
6.
If the thread is found to be loose due to wear and tear, it cannot be broken by hand, and it
should be cut short with scissors.
8. Casters inspection and maintenance
1.
Check the casters regularly, avoid hitting heavy objects or overloading, which will cause
damage to the casters.
2.
The casters should be applied with lubricating grease regularly, the frequency of appliance
should be determined according to the specific actual use situation. Under normal conditions,
the grease should be applied every six month.
3.
After cleaning the caster equipment, pay attention to adding lubricating grease. The selection of
lubricating grease should be based on the actual use environment, special high low
temperature environment, etc.
0.05～0.2% ammonium chloride
0.05～0.2% chlorinated phenyl
0.05% dichlorobenzene biguanide ethane
0.05～0.2% sodium hypochlorite
31
Publicité
