Publicité
2.2.- Operating and handling the stretcher
To prevent injuries to limbs and other body parts, make sure they are not within the range of
the moving parts of the trolley-stretcher.
Clarification: The front part of the stretcher corresponds to the head part.
2.2.1.- Removable cuffs
Press the button at the top of the cuff, and then pull it to lengthen the cuff, as far as it will go.
To return the cuff to its original position, press the top button again and push it as far as it will
go in the original position
2.2.2.- Method for fastening the safety belt
It is advisable for this belt to be attached to the stretcher and guarantee compliance with the
UNE-EN 1865 standard test that is performed.
Put the female part of the buckle A and male part B in the position shown in the figure below
and insert the latter into the slot in the former. Once the assembly is firmly secured, centre and
tauten it, adjusting the tension of the belt at end C.
It is advisable to ensure that while the body is on the stretcher, he/she is always secured by the
safety belts.
Rev.6
05.24
Top button
OPERATION AND HANDLING OF THE
TROLLEY-STRETCHER TGF-241S-S4
The top adhesive on the part of the
stretcher shown in the drawing on
the left indicates how to manipulate
the cuff to extend it.
7
Publicité
