Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
adJust tine height
The tine height is pre-adjusted for average lawn and
may not need to be changed. Changes can be made to
tine height if working conditions require it. Only make
adjustments to tine height when Electric Dethatcher is
turned off and unplugged from a power source. There are
5 positions for the tines (.7", .9", 1.1", 1.4" and 1.7"). Pull
adjustment arm out from engagement hole, move it and
then let it re-engage in the desired height position. Make
adjustments by 1-step increments only and alternate
between left and right sides when making adjustments.
Adjustment arms must always be same height position
when using the machine.
ADJUSTMENT ARM
Figure 8
trouBleshooting
ProBlem
noise in unit
whistling sound from unit
electric dethatcher not starting
motor cuts out during operation
dethatching is not satisfactory
ENGAGEMENT HOLE
Cause
Foreign objects in Electric Dethatcher.
Belt (part number 28) is slipping
Faulty cable/wiring.
Tine rotation blocked by foreign objects
Tine depth set too low.
Grass is too tall.
Spring tines have excessive wear.
Belt (part number 28) malfunctioning.
Grass is too tall.
rePlaCe damaged or worn
tines
If a tine becomes worn a damaged, it can be replaced.
To replace any worn or damaged tines, follow the steps
below:
1.
Make sure the dethatcher is turned off and unplugged
from a power source.
2.
Turn dethatcher over so tines can be easily accessed.
3.
Remove the six screws holding the section together
where the damaged tine resides and remove the top
section.
4.
Pull out damaged tine and replace it with a new tine.
5.
Reattach the top section removed in step 3 with the
screws that were removed.
Figure 9
6.
Turn off Electric Dethatcher, unplug from outlet
and wait for rotation to stop.
7.
Remove foreign objects from housing.
8.
Check Electric Dethatcher for any other
damage.
1.
Contact your local Sears Service Center.
1.
Contact your local Sears Service Center.
1.
Turn off Electric Dethatcher, unplug from outlet
and wait for rotation to stop.
2.
Remove foreign objects from housing.
3.
Wait approximately 1 minute and then plug-in
and turn on Electric Dethatcher.
1.
Turn off Electric Dethatcher, unplug from outlet
and wait for motor to cool down.
2.
Set tine depth to appropriate height.
1.
Mow lawn before using Electric Dethatcher.
1.
Replace spring tines (see Service and
Adjustments section on page 7.)
1.
Contact your local Sears Service Center.
1.
Mow lawn before using Electric Dethatcher.
7
CorreCtion
Publicité
Table des Matières
