Safety Instructions; Proper Use - IKA MTS 2/4 digital Mode D'emploi

Contents
Warranty
Safety instructions
Proper use
Unpacking
General information
Commissioning
Motor protection
Error codes
Maintenance and Cleaning
Technical data
List of spare parts MTS 2/4 digital
Spare parts diagram MTS 2/4 digital

Safety instructions

When adjusting the speed, pay careful attention to the containers
fastened onto the agitation table to prevent the medium to be sha-
ken from possibly splashing out. Select the speed based on how
full the container will be so as to prevent the medium from splas-
hing out. Observe applicable safety instructions and guidelines as
well as work protection and accident prevention requirements for
use in the laboratory. Avoid bumping and striking the agitation
table. Even minor damage that cannot be detected may result in
damage to the motor bearing. Careful handling will ensure safe
working and a long service life for the device.
If you notice that the device is not running smoothly, the speed
must always be reduced until no more unevenness occurs in the
operation.
8
Make certain that the
device is equipped with
at least two diagonally
Page
offset or four micro-titer
plates, whether or not
2
these are completely fil-
8
led. Never operate the
8
device without micro-
9
titer plates. Otherwise,
9
resonance may arise
10
when it runs at high speeds.
11
The micro-titer plates used for the agitation process must be secu-
11
rely fastened on the agitation table. Make certain in this regard to
12
lock the round band for clamping the micro-titer plates. It must be
12
replaced when necessary before it is too worn.
18
19
Only a specialist may open the device.
ATTENTION! Covers or parts that can be removed
from the device must be put in place on the device in
order tro ensure safe operation.
The IKA MTS 2/4 digital was not constructed for operation in dan-
gerous atmospheres, for mixing dangerous substances or for ope-
ration under water.
The instrument may not be operated in rooms with explosion
hazards. The device must be places on a level and skid-free hol-
ding surface.
Use only original IKA accessories.

Proper use

The IKA MTS 2/4 digital is designed for agitating from two to four
micro-titer plates.
012002