Transportation, Storage And Disposal - RedMax EBZ8550 Manuel D'utilisation

2. Examine the air intake screen for damages and
make sure that it is attached correctly.
3. Remove dirt, leaves and unwanted materials from
the air intake screen.
To clean the air filter
Clean the air filter regularly from dirt and dust. This
prevents carburetor malfunctions, starting problems,
loss of engine power, wear to engine parts and more
fuel consumption than usual. Clean the air filter at an
interval of 40 hours of operation or less if it is heavy
operation conditions.
1. Loosen the fasteners that holds the air filter cover in
position.
Transportation and storage
• For storage and transportation of the product and
fuel, make sure that there are no leaks or fumes.
Sparks or open flames, for example from electrical
devices or boilers, can start a fire.
• Always use approved containers for storage and
transportation of fuel.
962 - 003 - 01.02.2019

Transportation, storage and disposal

2. Remove the air filter cover (A).
3. Remove the foam filter (B) and the paper filter (C)
from the filter frame.
4. Replace the paper filter (C).
5. Clean the foam filter (B) with warm soap water.
Note: An air filter that is used for a long time can not
be fully cleaned. Replace the air filter regularly and
always replace a defective air filter.
6. Make sure that the foam filter (B) is dry.
7. Clean the inner surface of the air filter cover with a
brush (A).
To replace the harness
WARNING: A damaged harness can make
the product fall and cause injuries.
1. Stop the engine.
2. Remove the clamp from the strap.
3. Push the end of the strap through the hanger.
4. Pull the new strap through the hanger.
5. Attach the clamp to the new strap.
• Empty the fuel tank before transportation or before
long-term storage. Push the air purge bulb to make
sure that all fuel is removed. Discard the fuel at an
applicable disposal location.
• Make sure that the product is clean and that a
complete service is done before long time storage.
A
B
C
15