Operation - RedMax EBZ8550 Manuel D'utilisation

3. Attach and tighten the bolt, washer and nuts as
shown in the illustration.
4. Attach the control pipe (B) to the flexible tube (A)
with the clamp (D). Make sure that the mark on the
control pipe is up.
5. Attach the intermediate pipe (F) to the control pipe.
6. Attach the blower nozzle (G) to the intermediate
pipe.
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
Fuel
To use fuel
CAUTION: This product has a two-stroke
engine. Use a mixture of gasoline and two-
stroke engine oil. Make sure to use the
correct quantity of oil in the mixture.
Incorrect ratio of gasoline and oil can cause
damage to the engine.
10
7. Loosen the knob (H) to adjust the position of the
handle.
8. Tighten the knob again.
To adjust the harness
A correctly adjusted harness and product makes
operation easier.
1. Put on the harness of the product.
2. Tighten the side straps until the product is tight
against your body.

Operation

Redmax alkylate fuel
CAUTION: Do not use gasoline with an
octane number less than 90 RON (87 AKI).
This can cause damage to the product.
CAUTION: Do not use gasoline with more
than 10% ethanol concentration (E10). This
can cause damage to the product.
CAUTION: Do not use leaded gasoline. This
can cause damage to the product.
We recommend Redmax alkylate fuel for best
performance. This fuel gives less dangerous exhaust
fumes compared to regular fuel. It keeps the engine
clean and increases the engine life. Redmax alkylate
fuel is not available in all commercial areas.
H
962 - 003 - 01.02.2019