Browse Between Menus; Operation - Husqvarna AUTOMOWER 405X Manuel D'utilisation

33.15 Submenus
There are a number of submenus under each option.
You can access all the functions to set the product
settings via the submenus.
Certain submenus contain options that are ticked off to
the left. This means that these options are selected.
Check or uncheck the box by pushing the OK button.

33.16 Browse between menus

Browse through the main menu and submenus with the
help of the arrow buttons. Enter values and times using
the number buttons and confirm each selection with the
OK button. Push BACK to go up a step in the menu or
keep the MENU button pushed in for 2 seconds to go
directly to the main menu.
33.17 Main menu
Schedule
The lawn should not be cut too often to
obtain the best mowing result.
Consequently, it is important to limit the
operating time using this function if the
work area is less than the product's work
capacity. It is also an ideal tool to control
which periods the product should not
mow, for example when children are
playing on the lawn.
Cutting height
The cutting height can be varied from MIN
(1) to MAX (9). During the first week after
a new installation, the cutting height must
be set to MAX to avoid damaging the loop
wire. After this, the cutting height can be
lowered one step every week until the
desired cutting height has been reached.
Security
In this menu, settings relating to security
and the connection between the product
and the charging station can be made.
There are 3 security levels to choose
Low , Medium , High .
from:
34.1 To switch on, stop and switch off
the product
• To switch on the product, push the ON/OFF button
for 3 seconds and check that the indicator lamp is

86 - Operation

Messages
Historical fault and information messages
can be read in this menu. For some of the
most common fault messages, there are
tips and advice to help you rectify the
fault.
Weather timer
This function allows the product to
automatically adjust its mowing times
based on how much the lawn grows.
When the weather is good for grass
growth, the product mows more often and
when grass growth is low the product
automatically spends less time on the
lawn.
Installation
This menu function is used to customize
the installation. For many work areas
there is no need to alter the factory
settings, but depending on the lawn
complexity the mowing result can be
improved by making manual settings.
Settings
This selection allows you to make
changes to the general product settings
such as date and time. You can also
switch on/off
cutting , or save your settings in different
Profiles . Husqvarna recommends to let
ECO mode be turned on to save energy
and avoid interference with other
equipment.
Accessories
This menu handles the settings for the
product accessories, for example
Automower
Husqvarna representative for information
on what accessories are available for your
product.
34 Operation
lit. The product can only start if it is switched on
and the correct PIN code has been entered.
• To stop to product, push the STOP button on top
of the product. The product stops and the cutting
motor stops.
ECO mode and Spiral
®
Connect. Contact your local
1508 - 004 - 22.12.2020