Publicité
EN
Product Specifications
Models
Input
100-240V AC ~ 50-60 Hz,
BC1121
100W, 160-215VA
100-240V AC ~ 50-60 Hz,
BC1221
200W, 320-395VA
220-240V AC ~ 50-60 Hz,
BC1221-EU
200W, 340VA
Instructions for Charging Battery
The charger shall be installed near a socket-outlet that is easily accessible.
Do not charge battery pack when temperature is below 0°C (32°F) or above 45°C (113°F). Completely charge new battery packs before using.
Charging time is approximately 60-90 minutes.
Unplug charger and remove battery pack when not in use.
The dual bay charger is capable of independent and simultaneous charging of 12V and 20V batteries.
Action
Plug charger into AC power outlet.
Insert battery pack into charger.
Remove battery pack.
Legend: ä Flash l On m Off
Routine Maintenance
Unplug charger before cleaning. Plastic surfaces should only be cleaned with a slightly damp cloth. Keep vents free of dust and debris. Charger
should not be used with a damaged cord. Replacement cords and labels are available at nearest Authorized Ingersoll Rand Service Center.
Refer all communications to nearest Ingersoll Rand Office or Distributor.
Environmental Protection
When life of Ingersoll Rand electrical product has expired, it must be recycled in accordance with all applicable standards and regulations (local,
state, country, federal, etc.). Improper disposal may endanger environment.
Symbol Identification
Return waste material for recycling.
Original instructions are in English. Other languages are a translation of the original instructions.
EN-3
Output
12.6V DC 2.0A/21V DC 4.0A
USB Type A, 5V DC, 500mA,
D+/D- Connected, 200Ω
12.6V DC, 2.0A (x2)
21V DC, 4.0A (x2)
USB Type A, 5V DC, 500mA,
D+/D- Connected, 200Ω
Condition
Power On (Stand-By).
Charging.
Fuel gauge will indicate state of charge.
Communications Failure.
Battery Identification/Read Fault
Reinsert battery. Battery may be defective.
Initial Temperature.
Charging paused until battery has returned to safe temperature.
Time Out.
Charge time exceeded. Battery may be defective.
In Cycle Temperature.
Charging paused until battery has returned to safe temperature.
Over Voltage.
High voltage detected. Battery may be defective.
Over Current.
High current detected. Battery may be defective.
Charge Completed.
Battery Pack Removed.
Do not dispose of this product with
household waste material.
Battery
Model Number
BL2012 and BL2022
Charger Display
Green
Red
l
m
l
m
m
l
2 x ä
m
3 x ä
m
4 x ä
m
5 x ä
m
6 x ä
m
l
m
l
m
Li-ion
Product contains Lithium-ion. Do not dispose of
this product with household waste material.
Type
Li-ion
Alarm
Fuel
(Sound)
Gauge
-
mmmm
ämmm
-
Ê
Low ♪
mmmm
Low ♪
mmmm
Low ♪
mmmm
Low ♪
mmmm
Low ♪
mmmm
Low ♪
mmmm
High ♪
llll
High ♪
---
TL-G4911-LIK_ed4
Publicité
