Publicité
EN
Product Information: Cordless Tire Buffer
Product Safety Information
Intended Use:
This Cordless Tire Buffer is designed for drilling/reaming punctures and grinding tire surfaces for internal patchwork.
⚠
WARNING: Read all safety warnings, instructions, illustrations, and specifications provided with this power tool. Failure to follow the
warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference.
• Responsibly recycle or dispose of batteries. Do not puncture or burn batteries. Improper disposal may endanger the environment or cause
personal injury.
• Only use tools with appropriate voltage Ingersoll Rand batteries and charger. Use of any other batteries may create a risk of fire, personal
injury or property damage.
For additional information, refer to Cordless Tire Buffer Product Safety Manual Form TL-G4911-SIM, Battery Charger Safety Information
Manual Form 10567832 and Battery Safety Information Manual Form 10567840.
Manuals can be downloaded from ingersollrand.com
Product Specifications
Model
Buffing RPM
G4911
Model
G4911
† K
= 3dB measurement uncertainty
pA
‡ K
= 3dB measurement uncertainty
wA
* K = Vibration measurement uncertainty
Sound and vibration values were measured in compliance with internationally recognized test standards. The exposure to the user in a
specific tool application may vary from these results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.
Reamer Bits/Buffing Wheel Installation
Refer to Figure 3 on page 37.
Always remove the battery pack, before installing, removing or adjusting any accessory on this tool, or before performing any maintenance
on this tool or any accessory.
1. Move the Collet (B) forward and hold it.
2. Insert the Attachment (A) into the Collet (B).
3. Release the Collet (B).
4. Check to ensure the Attachment (A) is held securely in the Collet (B).
Reamer Bits/Buffing Wheel Adjustment
Refer to Figure 4 on page 37.
Always remove the battery pack, before installing, removing or adjusting any accessory on this tool, or before performing any
maintenance on this tool or any accessory.
1. Move the Collet (B) forward.
2. Move the Attachment (A) to desired position.
3. Release the Collet (B).
Parts and Maintenance
Tool repair and maintenance should only be carried out by an Authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
EN-1
Reaming RPM
0-3,000
0-1,000
Voltage
Battery Models
V, DC
20
BL2012 and BL2022
WARNING
Quick Change Collet
7/16" Hex
Sound level dB(A)
(EN/BS EN 60745)
† Pressure (L
)
‡ Power (L
p
66.1
Sound/Vibration values determined according to EN/BS EN 60745-2-23:2023.
Certified to CSA STD. C22.2 No. 62841-1.
WARNING
WARNING
WARNING
Max. Buffing
Max. Reaming
Accessory Ø
Accessory Ø
3"
Vibration (m/s
(EN/BS EN 60745)
)
Level
w
74.1
1.7
Conforms to UL STD. 62841-1.
TL-G4911-LIK_ed4
3/8"
)
2
*K
1.5
5026893
Publicité
