Working Instructions; Blade Maintenance - Gardeo GKIT10.8VLIT-3IN1T Traduction Des Instructions D'origine

WORKING INSTRUCTIONS

Hold the machine away from
Stand in a secure and stable
You may not start to operate
the machine until you have
read these operating
instructions, observed all the
instructions given and installed
the machine as described!
If persons who have blood
circulation problems are too
often exposed to vibrations
damages to the nervous
system or to blood vessels may
You can reduce vibrations:
- by thick and warm working
Vibrations
- shorter working time (have
See a doctor if your fingers
swell, you don't feel well or
your fingers become numb.
Shrub shear
Scare animals off the hedge
before starting to cut in
order to prevent them from
Cutting hedges
Before cutting check the hedge for foreign objects
e. g. wire fences.
Cut stems up to 8 mm in thickness. When cutting,
move steadily along the line of cut, so that stems
are fed directly into the cutter blades. The double
edge of the cutting blade enables cutting to either
direction, or with a side to side motion.
After use replace the blade transport guard.
Recommended cutting/trimming times:
– Cut hedges with deciduous leaves in June and
October.
– Cut evergreen hedges in April and August.
– Cut conifer and other fast growing shrubs approx.
every six weeks from May onwards.
Grass shear/Grass shear with
telescopic handle
Edging
Guide the machine along the edge of the lawn. Do
not allow the blade to contact paved surfaces,
stones or garden walls, since this will wear the
blade rapidly.
For larger lawn it is advisable to use the telescopic
handle (available as an accessory or supplier with
"grass shear and telescopic handle" set).
After use replace the blade transport guard.
yourself.
position.
occur.
gloves,
longer breaks).
being injured.
MAINTENANCE
• Always be sure that the tool is
battery cartridge is removed
before carrying out any
Note: To ensure long and reliable service, carry out
the following maintenance regularly.
Check for obvious defects such as loose, dislodged
or damaged blade, loose fixings and worn or
damaged components.
Check that covers and guards are undamaged and
correctly fitted. Carry out necessary maintenance or
repairs before using.
If the machine should happen to fail despite the care
taken in manufacturing and testing, repair should be
carried out by an authorized customer service agent
for GARDEO products.

BLADE MAINTENANCE

The card game does not stop immediately after
stopping.
Before you begin your repair work or maintenance,
wait until all parts are completely stopped.
After each use, clean regularly
blades and lubricate with maintenance spray.
To work longer cut, it is recommended to regularly
lubricate the blades with maintenance spray.
Check the condition of the cutting blade.
Make sure the blade is covered by the attached
protection when not in use.
Repairs and maintenance procedures before
using the device.
CAUTION:
switched off and the
work on the tool.
40