Gardeo GKIT10.8VLIT-3IN1T Traduction Des Instructions D'origine page 39

Installing or removing battery cartridge
• Hold the tool and the battery
installing or removing battery
hold the tool and the battery
cartridge firmly may cause
them to slip off your hands and
tool and battery cartridge and a
• Always release the on / off switch before inserting
or removing the battery.
• To remove the battery, remove it from the tool
while pressing the spring 6 on both sides of the
cartridge.
• To install the battery cartridge, align the tongue
on the battery cartridge with the groove in the
housing and slip it into place. Always insert it all the
way until it locks in place with a little click.
• Do not use force when installing the battery
cartridge. If the cartridge does not slide in easily, it
is not being inserted correctly.
Battery Charging
• Observe the mains voltage! The voltage of
the power supply must correspond with the
data given on the nameplate of the battery
charger. Battery chargers marked with 230 V
can also be operated with 220 V.
• Use only the charging unit supplied. Only this
charging unit is matched to the lithium-ion bat-
tery used in the product.
• The battery is equipped with temperature mon-
itoring that allows charging only in the tempera-
ture range between 0 ° C and 45 ° C. In this man-
ner, a high battery service life is achieved.
Note: The battery is supplied partially charged.
To ensure full capacity of the battery, complete-
ly charge the battery in the battery charger be-
fore using your power tool for the first time.
The lithium ion battery can be charged at any
time without reducing its service life. Interrupting the
charging procedure does not damage the battery.
CAUTION:
cartridge firmly when
cartridge. Failure to
result in damage to the
personal injury.
Charging Procedure
The charging procedure starts as soon as the
mains plug is plugged into the socket and the
battery is then inserted into the battery charger.
The indicator lights up in red during the charging
process. The battery is fully charged when the LED
turns green.
Unplug the battery charger from the mains supply
when not in use for long periods.
Charging Advice
With continuous or several repetitive charging
cycles without interruption, the charger can
warm up. This is not meaningful and does not in-
dicate a technical defect of the battery charger.
A significantly reduced working period after
charging indicates that the battery is used and
must be replaced.
the lithium ion battery against deep discharging.
When the battery is run down or discharged, the
garden product is shut off by means of a protec-
tive circuit: The blade no longer moves.
Do not continue to press the
On/Off switch after the garden
product has been automatically
The battery can be damaged.
WARNING
switched off.
39