Publicité
Replacing the oven light bulb
Warning:
Make sure that the appliance has been disconnected from the electrical power
supply before replacing the light bulb, to avoid any risk of electrical shock.
Bulb: 230 V ~ 15 W Max. E14 fitting.
1. Make sure that the buttons are in the "Off" position, then unplug the
appliance from the power supply.
2. Remove the protective cover. If you struggle to turn it, use a rubber glove.
Clean it and fully dry it.
3. Remove the bulb and replace it will a bulb which has specifications that
are identical to those of the original.
4. Replace the bulb, then put the cover back into place.
7. QUICK TROUBLESHOOTING GUIDE
In each emergency situation, you need to:
- Set the oven's dials to the 0 position
- Unplug the appliance from the power source
- Contact the after-sales service
Minor malfunctions can be resolved by users using the table below.
Before contacting customer services or the after-sales service, please refer to this table:
Possible breakdowns
The appliance is not working
properly
Steam comes out of the oven
during operation
Metallic noises can be heard
when the oven is heating and
cooling
The oven isn't heating
The oven door isn't opening
properly.
The oven's external surface
becomes extremely hot when
the oven is in use.
Causes and solutions
- Check that the power cable is properly plugged in.
- The fuse isn't working or has short-circuited. Check the fuses.
If the fuse has short-circuited, remove or replace it.
- There may have been a surge in the electrical network.
Unplug the power cable from the power socket and then plug
it back in.
- There may not be any power. Check that the power supply
is working and the fuses are set properly. If necessary,
reset the fuses.
It is normal to see steam while the oven is in operation.
This is not a breakdown.
When metal parts heat up, they may make noises as they
expand. This is not a malfunction or a breakdown.
The mode and/or temperature dial(s) may not be set.
Adjust them.
Food residue may be stuck between the door and the internal
cavity. Thoroughly clean the oven and try to reopen the door.
This breakdown may be caused by the oven not being installed
in a sufficiently ventilated location.
Make sure that the clearances specified in the user instructions
are maintained.
17
EN
Publicité
