Publicité
For re-assembly
EN
1. Position the door so that it is facing the two hinges
2. Lower the small hooks using a screwdriver, and adjust the door's two hinges to the same
position
3. Check that the locking operation has been effectively carried out, and close the oven door.
The inner glass panel can be removed for easier cleaning. This operation must only be carried out
when the oven is cool.
To dismantle the glass panel:
- Fully open the door and press the plastic latches on each side of the door (Figure 3).
- Pull the upper section of the door frame towards you (Figure 4).
- Lift the interior glass panel to remove it (Figure 5). Clean the glass panel and then dry it.
Figure 3
To re-assemble the glass panel:
- Replace the glass panel with the upper section of the door frame by pushing it in towards
the inside of the oven. Make sure that the words "THERMAL REFLECTOR" are facing you.
(See Diagram below for the direction of the glass panel)
- Press down on the latches to lock the glass panel in place and close the oven door.
Use a cleaning product for glass to clean the inside and outside of the oven door. Wipe down with
a damp cloth and then clean water, and dry using a soft, dry cloth.
Figure 4
16
Figure 5
Publicité
