Publicité
• When selecting
each rotation direction.
PRECAUTIONS
• When using the rotary file, set the angle of CW bigger
than CCW.
• When using the reciprocating file, set the angle of
CCW bigger than CW.
• When
[Adaptive]
• The
[Adaptive]
file to reduce the possibility of file separation and at the
same time increasing the efficiency, which is suitable for
narrow root canals.
• When selecting [CW], or
be set.
• [R&S]: When the set torque limit is reached, the motor
rotates in the opposite direction of the current setting
until the load decreases, and then it stops.
• [REV]: When the set torque limit value is reached, the
motor rotates in the opposite direction of the current
setting until the load decreases. It then rotates again in the
currently set direction.
NOTE:
• The setting menu appears different depending on the motor
operation method.
• When in
[Adaptive]
automatically set to [REV].
5. Repeat steps 2 to 4 to program additional motor operations
to the memory.
6. Press any two buttons simultaneously for 2 seconds to turn
off the power. The memory is saved.
SYSTEM SETTINGS
Follow the steps below to change the system settings for the
motor handpiece.
1. With the device powered off, press the
the
[ ]
button at the same time. The power turns on, and
the settings screen appears on the display.
2. Press the
[ ]
button until the desired menu appears, then
press the
[
/
]
[Dominant
hand]: Set the screen direction RIGHT and
•
LEFT to suit the main hand of the operator. (Default: RIGHT)
• [VOLUME]: Set the alarm volume between VOL.0 and
VOL.3. (Default: VOL.2)
[Auto power
off]: Set a standby time of the device being
•
turned off after a certain period of inactivity. The standby
time can be set between 1 and 10 minutes, in 1-minute
increments. (Default: 5 minutes)
7
[RCP]
the rotation angle can be set for
is selected, Adaptive motion can be set.
mode reduces the torsional stress of the
[CCW]
the autoreverse option can
mode, the auto-reverse option is
[Main]
button to select a value.
3. Press the
ADVANCED SETTINGS
Linking the Elements Connect Cordless Endodontic Motor
to the Apex Connect
This device can be used in conjunction with the Apex Connect.
By connecting the two devices, the working length of the canal
while instrumenting the canal can be measured.
PRECAUTIONS
• This device is designed to be compatible with the Apex Connect.
• Use the USB connection terminal on this device only to connect
1
Apex Connect Components
The components of Apex Connect required to link are as follows.
NOTE:
• For more information on the components of the Kerr Apex
2
Assembly and Connection
1. Plug the USB connector on one end of the probe cord into
button and
PRECAUTIONS
The USB connector (Type C) on the probe cord has its intended
use. Examine the role of each connector and connect to the
appropriate device.
• Single USB connector: Apex Connect Unit connection
• USB connector supplied with lip hook connector:
2. Insert the lip hook into the lip hook connector of the
PRECAUTION
Be sure to clean and sterilize the lip hook before each use.
[Main]
button. The settings are saved, and return
to the main screen.
Do not connect any other device other than Apex Connect.
Apex Connect. Do not connect the charging USB cable.
Apex Connect Unit
Probe Cord
Locator and how to use them, refer to the "Apex Connect
Instructions for use."
the USB connection terminal on the motor handpiece and
the other end into the USB connector on the main unit.
Motor handpiece and file holder connection
probe cord.
Lip Hook
Publicité
