V1.0
7.
Reattach the battery to the tool.
REPLACING THE CUTTING BLADE
1.
Loosen and remove the screws for the shield guard (Fig. 8).
2.
Push in the spindle lock lever (Fig. 9), while using the supplied hex
wrench to rotate the blade until the spindle lock lever engages and
locks the blade in place (Fig. 10). Once locked, the blade will not rotate.
3.
Holding the spindle lock lever in place,
use the hex wrench (Fig. 11-1) to
remove the hexagonal bolt (Fig. 11-2).
4.
Remove the out flange (Fig. 11-3).
5.
Raise the removable guard (#66) to its
highest position.
6.
Remove the old blade.
7.
Insert the new blade, spinning it by
hand to ensure proper rotational
direction, no defects and that it fits (Fig. 11-4).
8.
If the inner flange (Fig. 11-5) was removed, be sure to install it on the
spindle (Fig. 11-6).
9.
Place the outer flange and hexagonal bolt through the threaded arbor
hole and tighten with your fingers.
10. Push in the spindle lock lever while tightening the hex bolt.
Visit www.princessauto.com for more information
20V Cordless Brushless Dry Cut Metal Saw
Fig. 8
Fig. 9
9095738
Fig. 10
Fig. 11
13