Blendtec Commercial Serie Manuel Du Propriétaire page 7

provides fast, consistent blending. NOTE: Never operate the
blender with more than the marked capacity of the jar.
3.3 POWER SPECIFICATIONS
Your Commercial series blender is certified for use with a specific
circuit voltage, depending on the model. Make sure to check your
model's power specifications and use a protected circuit when
operating your unit.
SECTION 4
CARE & CLEANING
4.1 CLEANING AFTER USE
1. Add hot water and 1-2 drops of liquid dish soap to the
blender jar.
2. Place the lid tightly onto the jar, place the jar on the motor
base and pulse at speed 7 for 5-10 seconds.
3. Rinse all soap from the jar and lid with water.
4. If the jar is stored upside down, shake excess water from the
jar after cleaning. Note: WildSide+™ and FourSide™ jars can
be stacked to save space.
4.2 LONG-TERM SANITATION
1. Sanitize the jar per local code by filling the blender jar with
a sanitizer diluted to the manufacturer's specifications.
Bleach, properly diluted, can be used.
2. Leave the diluted sanitizer in the jar for 5 minutes.
3. Empty the sanitizer from the jar.
4. Rinse jar thoroughly with water.
5. If the jar is stored upside down, shake excess water from the
jar after cleaning.
4.3 MOTOR BASE CLEANING
1. Ensure the blender is unplugged before cleaning.
2. Wipe down the plastic housing of the motor base, controls,
and gaskets with a clean, damp rag. A mild, all-purpose,
nonabrasive cleaner may be used.
3. The drive socket can be cleaned using a cotton swab
or toothpick.
4.4 CLEANING TIPS AND CAUTIONS
• Do not use stiff bristled brushes or abrasive cloths/pads to
clean the blender base, jar, lid or tamper as this will dull or
scratch the surface.
• Do not use a water jet of any kind to clean the motor base.
• NEVER submerge the motor base in water. Doing so will void
the warranty.
• Avoid submerging blender jars for more than 5 minutes.
Water penetration through the lower jar seals will reduce the
life of the jar.
SECTION 5
WARRANTY
5.1 WARRANTY DESCRIPTION
Blendtec warrants your blender against defects in materials and
®
workmanship under normal use, maintnance, and service for 1–3 years*
on parts and labor required to repair or replace components that, in
the sole discretion of Blendtec, are defective. In order to honor your
warranty, Blendtec will require a serial number, model number, and
proof of purchase from an authorized dealer at the time of the claim.
In addition, the serial number label on the unit must remain
intact and unaltered or the warranty is void. The following items
are not included in the blender warranty coverage:
• Normal maintenance, adjustments and cleaning as outlined
in this manual.
• Repairs due to unauthorized service or modifications to the
blender, product tampering or use of non-standard parts or
accessories without prior written approval from Blendtec.
• Damage caused by: improper installation or ventilation of
the blender; electrical supply (e.g., electrical power failure,
improper electrical connections, the use of extension cords,
low voltage or voltage drops to the unit); water supply;
drainage; exposure to water; or floods, storms or other acts
of God.
7