Télécharger Imprimer la page

BESAFE Stretch Manuel D'utilisation page 20

Publicité

20
the seat. See section "Preparing the child seat for installation".
Cushion inserts
Remove the bottom cushion when the child is over 2 years. (26)
Remove the back cushion when the child is over 2 years or earlier when
the child does not fit between the cushion anymore. (26)
Removing and refitting the cover
Do take care when you remove the cover, as re-fitting the cover is done in
reverse.
The cover of the headrest can be taken off separately.
For further instructions, please visit www.besafe.com
When washing the seat cover, make sure to follow the wash label on the
inside of the cover.
! Warning: potential misuse
The child seat MUST NOT be installed in a front passenger
seat WITH AN ACTIVATED AIRBAG.
The child seat MUST NOT be installed in a position where
the vehicle belt is equipped with a belt airbag that cannot be
deactivated.
The floor support must always be used. Make sure that the floor support
is fully pushed down and in full contact with the vehicle floor.
Make sure that the vehicle belt is installed tight, the lock-off is closed and
tensioned and that both lower tethers are connected with the vehicle and
tensioned tight.
Guarantee
Should this product prove faulty within 24 months of purchase due to
materials or manufacturing fault, except covers and harness straps,
please return it to the original place of purchase.
The guarantee is only valid when you use your seat appropriately and
with care. Please contact your retailer, they will decide if the seat will be
returned to the manufacturer for repair. Replacement or return cannot be
claimed. The guarantee is not extended through repair.
The guarantee expires: when there is no receipt, when defects are caused
by incorrect and improper use, when defects are caused by abuse,
misuse or negligence.

Publicité

loading