Publicité
the vehicle seat. Regularly check that the bracket still sits tight and as
positioned, or re-tighten the bolt if needed.
Installing the child seat into the vehicle
1.
Once the anchorage points for the lower tethers are in position, the
installation can continue.
2.
Place the child seat onto the vehicle seat with the front brace positioned
against the backrest of the vehicle seat. (9)
3.
Remove the yellow cap from the floor support. The alarm sound will stop
when the seat is installed correctly with the floor support in contact with
the floor of the vehicle.
4.
Extend the floor support with the floor support handle, so that it is in
contact with the vehicle floor while the child seat sits flush on the vehicle
seat. This prevents the child seat from tipping backwards. (10)
5.
Pull the vehicle belt out long and combine shoulder belt and lap belt with
one hand. With the other hand, guide the belt tongue through the first belt
guider, through the tensioner-lock-off, through the second belt guider and
click it into the buckle. Make sure both belts sit underneath the ledge on
the base and fully inside the tensioner-lock-off. (11, 12)
6.
To remove slack in the belt, first pull on ONLY the shoulder belt near the
buckle. Then, pull on the shoulder belt on the door side while making sure
the child seat does not move. (13)
7.
When all slack is removed, rotate the tensioner knob clockwise at the
backside of the seat. When doing so, the tensioner-lock-off at the front
side will close. Continue rotating the knob to tension the belt. You can
rotate until the knob will click and doesn't tension any further. (14)
8.
Note: check that the vehicle belt buckle is not in conflict with the belt
guider. Should this be the case, you need to install the seat with a larger
front brace position.
9.
Check that the floor support is still in contact with the vehicle floor and
adjust if needed.
10.
The height indicator of the floor support shows green when the floor
support is in contact with the floor.
11.
The alarm sound stops when the floor support height indicators show
green and it is in contact with the floor (not on all models).
12.
Push down the lower tether release button and pull out the lower tethers.
Connect the hook to the lower tether anchorages of the vehicle. Repeat
the same procedure on the other side. (15)
13.
Ensure that both lower tethers are connected and tight. By wiggling the
seat from side to side, they will become more tight.
14.
Make sure that you can still see the yellow line on each lower tether
17
Publicité
