Publicité
• Insert the batteries (see chapter "Technical specifications").
Insert the batteries, making sure the polarity is correct accord-
ing to the label
.
A
• Close the battery compartment cover.
If the
symbol is displayed and does not disappear, meas-
urement is no longer possible. Replace all the batteries. Once the
batteries have been removed from the device, the date and time
must be set again. Any saved measured values are retained.
Operation with the mains part
You can also operate this device with a mains part (not included in
delivery). However, before connecting the device with the mains
part, please ensure that you have removed the batteries from the
device. During mains operation, there must not be any batteries in
the battery compartment, as this could damage the device.
• To avoid any potential damage, the device may only be oper-
ated with a mains part that meets the specifications described
in the chapter "Technical specifications".
• Furthermore, the mains part must only be connected to the
mains voltage that is specified on the type plate.
• Insert the mains adapter into the connection provided for this
purpose on the blood pressure monitor.
• Then insert the mains plug of the mains part into the mains
socket.
• After using the blood pressure monitor, unplug the mains part
from the mains socket first and then disconnect it from the
blood pressure monitor. As soon as you unplug the mains
part, the blood pressure monitor loses the date and time set-
ting but the saved measured values are retained.
Adjusting the settings
Make sure that the device's settings have been set correctly so
you can make full use of all its functions. Otherwise you will not
be able to save your measured values with the date and time and
access them later.
There are two di erent ways to access the settings menu:
• Before initial use and after each time you replace the battery:
When inserting batteries into the device, you will be taken to
the relevant menu automatically.
• If the batteries have already been inserted:
With the device switched o , press and hold the setting but-
ton SET for approx. 5 seconds.
Set these settings in the order shown below:
Hour format
Date
Press SET to confirm your selection each time.
Time format
Time format flashes:
• Press -/+ to select the time for-
mat.
28
Time
Publicité
