Gps.info.page; Gps Settings - Kenwood KNA-G510 Mode D'emploi

GPS Info Page
From the Menu page, touch the signal strength bars in
the upper left corner to view the GPS Info page. Or, from
Tools
the Menu page, touch
Sky view
Satellite signal
strength bars
The sky view shows the satellites you are receiving. The
satellite signal strength bars indicate the strength of each
satellite you are receiving. A solid bar indicates the GPS
satellite is ready for use.
KNA-G510 Instruction Manual
Navigation GpS Info.
> >

GPS Settings

From the Menu page, touch
You can also access the GPS Settings by touching the
GpS Settings button on the GPS Info page.
Use Indoors—touch Yes
Set position—set your position, if Use Indoors is
enabled. Select your location on the map and touch oK.
WAAS/EGNoS—disable and enable WAAS/EGNOS.
WAAS and EGNOS are systems of satellites and ground
stations that provide GPS signal corrections, giving you
even better position accuracy. To learn about WAAS and
EGNOS, visit http://www.garmin.com/aboutGPS/waas
.html.
V  M  U 
ieWinG the aP and sinG the
Settings > General > GpS.
to turn the GPS receiver off.
t
ooLs
EN-1