Beurer BY 33 Mode D'emploi page 24

6. INITIAL USE
Baby unit
Operation with mains part
Position the baby unit so that it is in an elevated position and is not in proximity to
any other devices that may cause interference.
Using the mains part plug, connect the baby unit to a socket.
The device automatically switches on.
The power LED will light up green.
To switch the device o press the ON/OFF button for at least 2 seconds or unplug
the mains part. The power LED will go out.
To switch the device on again press the ON/OFF button for approx. 2 seconds.
Parent unit
Set up the parent unit in the room where you are going to be.
Battery operation – charging
To ensure optimal safety, the parent unit is designed so that it can only
be operated with batteries inserted.
The battery must be charged for at least 16 hours before the device can be first used
independently of the mains; you may use the device during this period.
Switch the parent unit on by pressing the
of the parent unit will light up green. The device is active.
If the parent unit battery is low the unit will beep twice. If the device is not connected
to a socket, it will switch o automatically after a short period. The power LED will
go out.
button for 2 seconds. The power LED
24