Télécharger Imprimer la page

Toto LT307R Manuel D'installation page 3

Publicité

DO NOT OVERTIGHTEN HARDWARE. Overtightening hardware may
damage the products and cause personal injury and/or property damage.
WARNING
Installation using carrier
1.
Install the faucets and drain (not supplied) per the manufacturer's instructions.
2.
Slide lavatory over carrier arms.
3.
Use the screws on the underside front and back holes to level the lavatory.
4.
Use the underside center holes to lock the lavatory in place.
Installation using hangers (LT307R only)
1. Place the lavatory on the hangers. Brace it
adequately so that the lavatory cannot tip over.
2. Verify that the lavatory is level and at the correct
height (see Ill. 3). Mark the location of the mounting
holes.
NOTE: To help recall the lavatory position, trace a
line along the sides and top edge of the lavatory
with a pencil.
3. Remove the lavatory from the hangers.
4. Drill the remaining holes for the mounting
hangers and install the four remaining screws
(see ill. 4).
5. Install the faucets and drain (not supplied) per the
manufacturer's instructions.
6. Return the lavatory into position.
7. Install the lag screws and washers (not supplied).
(see Ill. 5).
A. Place the washers onto the lag screws and insert
the screws through the mounting holes in the
lavatory and into the wall. Do not tighten at this
time.
B. Verify the lavatory is level with the mark along
the top and sides of the lavatory and secure the
lavatory to the wall by tightening screws.
1.
Connect the water supply to the faucet according to the faucet instructions.
2.
Connect and tighten the p-trap to the drain.
3.
Turn on the water supplies to the faucet.
4.
Purge air from the hot and cold water by running the water for a few seconds.
5.
Fill the lavatory with water.
6.
Check for any leaks at the water supply and drain connections.
INSTALLATION PROCEDURE
AFTER INSTALLATION
Ill. 3
Ill. 4
Screw
Ill. 5
3
Hanger
Hanger
Screw

Publicité

loading