Rothenberger ROMAX 4000 AMPShare Instructions D'utilisation page 22

RO BP 18V ProCORE AMPShare
LED
5× continuous green light
4× continuous green light
3× continuous green light
2× continuous green light
1× continuous green light
1× flashing green light
Recommendations for Optimal Handling of the Battery:
Protect the battery against moisture and water.
Only store the battery within a temperature range of −20 to 50 C. Do not leave the battery in
your car in the summer, for example.
Occasionally clean the ventilation slots on the battery using a soft brush that is clean and dry.
A significantly reduced operating time after charging indicates that the battery has deteriorated
and must be replaced.
Follow the instructions on correct disposal!
3.2 EMERGENCY STOP Button
If there is any danger to personnel or the machine during the pressing process, press the
EMERGENCY STOP button immediately and release the ON switch. The valve will open and
the piston will return to its initial position.
3.3 To switch on
Press the ON button until the pressing process has been completed. The motor cut out indicates
the end of the moulding cycle.
3.4 To turn the press jaw
The press jaw can be turned through 270° depending on the application.
3.5 LED
White LED lights up for 5s after a short keystroke or completed pressing.
White LED flashes when battery level is low.
3.6 To insert the press jaw
Remove battery!
 Open the bolt (1).
 Insert the appropriate press jaw for the job in hand (2).
 Lock the bolt (3).
After changing the press jaw it is essential to ensure that, once engaged, the crimping jaw
matches the profile being moulded and the nominal width of the fitting being moulded. A visual
inspection must be carried out in order to determine that the press jaw is fully closed at the end
of the press cycle.
3.7 Operation
Use only system-compatible press fittings and press jaws designed for them. The nominal size
of the press jaw must be identical with the nominal size of the press fitting.
When inserting the pipe / press fitting system, there is a risk of crush injuries for the
fingers or other body parts near the press jaw!
 Push the press fitting on to the pipe (1). Pull the press jaw apart and insert the pipe with the
press fitting at right angles.
There must be no foreign bodies between the press contour and the fitting. If you fail to
ensure this, the pressing process will not produce a perfect joint!
16
RO BP 18V AMPShare
Capacity LED
80–100 % 3× continuous green light
60–80 % 2× continuous green light
40–60 % 1× continuous green light
20–40 % 1× flashing green light
5–20 %
0–5 %
ENGLISH
Capacity
60–100 %
30–60 %
5–30 %
0–5 %
(B-1)
(B-2)
(B-3)
(C)
(D)
(E)