Maintenance; Spare Parts - Wolf Garten Compact plus 34 AC Mode D'emploi

Emptying of Grassbox
When the collection bag is full, the flap lowers by itself.
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
Switch the motor off and pull the plug bracket out.
Empty collection bag.
Remove potential blockages in the cutting space before
starting.
3
Instructions for level indicator:
For an efficient functioning of the level indicator, regularly
clean the holes under the level indicator in the collection
bag with a hand brush.
Mulch
„Mulching" is a process in which the grass is finely chopped by a
special cutting system and then deposited on the ground. The re-
sult is that the grass does not have to be collected and disposed
of. „Mulching" also prevents the lawn from drying out.
3
Instructions for mulching
We recommend:
Depending on the growth of grass, mulch 1 – 2 x per
week
The grass should not be too high nor too wet!
Go slow while mulching
Take care that the blade channels do overlap.
Do not cut grass more than 20 mm.

Maintenance

General
1
Attention! Rotary cutter blade
Before all maintenance and cleaning work:
Pull the plug bracket out.
Do not touch running blades.
Cleaning
Clean mower thoroughly after each mowing with cloth or
brush.
Clean the mulch flap at regular intervals with a small
broom .
T
Do not spray with water.
Winter Storage
Clean mower thoroughly before storing away.

Spare parts

Item number
4904 031
4908 096
4908 072
16
S
Order description
Vi 34 X
3
Note:
Mulching is not advisable in case of moss-affected or
entangled grass, because the cut material stays on the
moss surface and/or entanglement and thus cannot be
absorbed by the ground.
Regularly scarify and manure the lawn.
Activating the mulch function
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
Do not start the motor until your feet are at a safe dis-
tance from the cutting tool.
1. Remove the grass collecting bag.
2. Set the switch to „MULCH".
3. Start the motor.
Have your mower thoroughly checked once a year by an ap-
proved Service Centre.
Do not store it in a wet or humid place.
Changing blades
U
Caution! - Sharp cutting blades - pull the plug bracket out
before performing any maintenance work.
1
Attention!
An unbalance can develop after regrinding of the blade.
Always regrind the blades in a specialist workshop,
because an unbalance check should be undertaken
according to the safety regulations.
Always change blades in a specialist workshop. A torque
spanner of 10 mm is mandatorily required.
Fastening torque of the screws: 6 - 7 N-m
Product information
Grass catcher
Replacement blade 34 cm
Charger
Q
U
.
G