Cancellation Of Signals; Short Instructions - Opening With Override Key - Kaba Mauer 82132 Code-Combi B Mode D'emploi

4.7.3 Cancellation of signals

If the aluminium control unit has been completely unscrewed the lock's electronic systems
recognise and record this. An appropriate alarm signal then appears every time the lock is
opened. The cancellation of this signal can only be done by the primary code holder (in paral-
lel mode) or by the dual code holder (in ordinary dual code mode) (see 4.5.2).
4.8 Short instructions – opening with override key
For cutting:
Opening with override key (plastic input unit)
1. Press tool into the right
hand hole until catch
loosens.
Hold the tool pressed in
and carefully raise the
cover plate.
3. Remove bar handle and
drive shaft (square end)
(lift off contact activated
acoustic signal).
Diagram 6: Plastic input unit
Kaba Mauer GmbH
2. Repeat the process on
the left hand hole and
carefully lift off the cover
plate.
4. Insert key (long bit left)
and turn clockwise until
stop position reached.
82132 Code-Combi B
Opening with override key (aluminium input unit)
1. Insert Allen key into rear
hole and loosen screw
inside. Do not completely
unscrew it.
3. If shaft mounting covers
keyhole, pull out Allen key.
Adjust shaft mounting
with aid of drive shaft
(square end) as to reveal
the keyhole.
Diagram 7: Aluminium input unit
GB
2. Pull out bar handle with
drive shaft (square end).
4. Insert key and turn clock-
wise until stop position
reached (key cannot be
removed).
Page 39