Opening With Programmed Td/Ow; Cancellation Of Programmed Td/Ow; Power Supply; Enter Valid Code 1 X - Kaba Mauer 82132 Code-Combi B Mode D'emploi

4.4.2 Opening with programmed TD/OW

1) Press ON
2) Enter valid code
Automatic start of TD: visual signal every 5 seconds
After end of TD: acoustic signal
Automatic start of OW: visual and acoustic signal every 5 seconds
3) Enter valid code once again during OW period
4) Within 4 seconds turn bar handle clockwise until stop position reached
By pressing the P key during the TD period this function is interrupted. The entire sequence
must then be repeated in order to open again.
3 code entries are possible during the OW period. Following the third incorrect entry the
entire process has to be repeated. The TD/OW can be overridden with the override key
(see 4.6 or 4.7).

4.4.3 Cancellation of programmed TD/OW

1) Open lock with valid code
2) Press ON
3) Press P
4) Enter valid code once more
5) Press P
Press 1 when TD/OW is entered for
- primary code in parallel mode
- primary code in delegated dual code mode
6) - dual code in ordinary dual code mode
Press 2 when TD/OW is entered for
- secondary code in parallel mode
- dual code in delegated dual code mode
7) Press 000 (set TD/OW on 0 respectively)

4.5 Power supply

The lock is powered by means of a 9-volt block battery (exception: power supply by alarm
system). We recommend using an alkaline/manganese battery with reduced heavy metal
content.
When changing the battery, please dispose of old batteries in an environmentally friendly
manner using recycling/collecting boxes. Batteries should never be thrown on the fi re, into
water or thrown away with normal household waste.
Kaba Mauer GmbH 82132 Code-Combi B
GB
1 x
1 x
/
1 x
1 x
TD/OW
deleted
Page 33