Using The Pole Hedge Trimmer - PrimAster PMTHS 600 Manuel D'utilisation

Switching on/out
• Press with your thumbs the stopping button (9) on
the left side of the rear handle and then the operating
switch (10).
• The stopping button (9) is used for unlocking the
switch-on mechanism and does not need to be
pressed again after the device is switched on.
• To switch off the device, release switch (10).
Note: The sparks (flashes) developing from this in the
area of the upper ventilation slots are normal and harm-
less for the device.
Attachment of the shoulder belt
1. Wear the shoulder belt so that it lies over the right-
shoulder.
2. Fasten the snap hook on the shaft bracket on the
shaft (6).
9
10
13
6
7
Never carry the belt diagonally across your shoulders
and chest, but rather only on one shoulder, so that you
can rapidly move away from the tool in case of danger.
Instructions for use of the equipment
• Do not use the trimmer in rain or for cutting wet hedges!
• Check the hedge trimmer flex and its connections
before each and every use for visible signs of damage
(disconnect the power plug)! Do not use a faulty flex.
• Gloves:
Protective gloves must be worn when using the hedge
trimmer.

Using the pole hedge trimmer

The Pole Trimmer is a dual- purpose tool. It is designed
to trim and shape tall, hard-to-reach hedges and bushes
with its extended reach and pivoting power head. You
can also adjust the Pole Trimmer to trim and shape
smaller hedges and shrubs near the ground without hav-
ing to bend or stoop.
To use the Pole Trimmer for trimming tall, hard-to-reach
hedges or shrubs, hold the Pole Trimmer at the positions
shown. Pivot the power head to several different posi-
tions to shape or sculpt shrubs or hedges.
GB-12