PrimAster PMTHS 600 Manuel D'utilisation page 43

Remove transport protection
Before starting with the installation as described in the
operating instructions, please carry out the following
steps:
1. Pull the inner telescopic tube approx. 5 cm out of the
outer sleeve.
2. Then remove the rubber stopper. This is only required
as transport protection for the cable.
ca. 5 cm
2
Assembly
There are three lugs inside the tube sleeve (A) on the
cutter head which must engage in the recesses in the
hexagonal tube. Place the device on a level surface as
shown in the figure below. The side of the hexagonal tube
in which there is only one recess must face upwards (B).
1. Slide the cutter head onto the tube in this position (to
1
2. Tighten screw sleeve 14 by turning it clockwise ( ) to
GB-10
do so, screw sleeve 14 must be loosened by turning
anticlockwise ( )). The lugs must engage audibly in
the recesses.
fasten the cutter head on the tube.
14
A
B
14