Installer Checklist; To Clean And Protect Exterior Surfaces - Thermador Professional PRO-HARMONY DP30 Instructions D'installation

FINAL CHECK LIST
Specified clearances main-
tained to cabinet surfaces.
Unit Level – front to back –
side to side.
Burner caps positioned prop-
erly on burner bases.
All packaging material removed.
Island trim or backguard at-
tached according to instruc-
tions.
Kick panel in place and two (2)
screws secure.
The griddle or grill plate and
frame is correctly positioned,
tilted slightly forward. (See page
9 for adjustment procedure.)

To Clean and Protect Exterior Surfaces

The stainless steel surfaces may be cleaned by
wiping with a damp soapy cloth, rinsing with clear
water and drying with a soft cloth to avoid water
marks. Any mild glass cleaner will remove fingerprints
and smears.
For discolorations or deposits that persist, refer to the
Care and Use Manual.
To polish and protect the stainless steel, use a cleaner/
polish such as Stainless Steel Magic

INSTALLER CHECKLIST

GAS SUPPLY
Manual gas shut off valve in-
stalled in an accessible loca-
tion (without requiring removal
of range).
Unit tested and free of gas
leaks.
If used on propane gas, verify
that the propane gas supply is
equipped with its own high pres-
sure regulator in addition to the
pressure regulator supplied
with the appliance.
ELECTRICAL
Receptacle with correct over-
current protection is provided
for service cord connection.
Proper ground connection.
DO NOT allow deposits to remain for long periods of
time.
DO NOT use ordinary steel wool or steel brushes.
Small bits of steel may adhere to the surface causing
rust.
DO NOT allow salt solutions, disinfectants, bleaches
or cleaning compounds to remain in contact with
stainless steel for extended periods. Many of these
compounds contain chemicals which could prove
®
.
harmful. Rinse with water after exposure and wipe dry
with a clean cloth.
20
OPERATION
Bezels centered on burner
knobs, and knobs turn freely.
Each burner lights satisfacto-
rily, both individually and with
other burners operating.
Griddle or grill is tilted slightly
forward and does not rock (not
all models).
Oven door hinges seated and
hinge locks in proper position.
Door opens and closes prop-
erly.
Burner grates correctly posi-
tioned, level, and do not rock.
Start self-clean. When LOCK
light comes on, verify that door
is locked close. Cancel self
clean mode.
INSTALLER: Leave the Care
and Use Manual and Installa-
tion Instructions with the owner
of the appliance.