Cembre HT45 Notice D'utilisation Et Entretien page 4

Make sure that dies are exactly positioned on desired crimp point; otherwise, re-open dies
following instructions as per § 2.4 and position the connector again.
2.3) Crimping
Continue to operate the moveable handle (36), the ram will gradually advance until the dies meet.
It is recommended to continue pumping until the maximum pressure valve is activated and a
"click" is heard.
2.4) Dies re-opening
Press the pressure release lever (50) for the rapid retraction of the ram and subsequent dies re-
opening of the dies to release the crimped connector.
2.5) Rest setting
After completion of the work, press the release lever to release the oil pressure.
Fit the handle holder (01).
The tool is robust and requires very little daily maintenance.
Compliance with the following points, should help to maintain the optimum performance of the tool.
3.1) Accurate cleaning
Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be cleaned with a clean cloth, taking care to remove any residual,
especially close to pivots and moveable parts.
3.2) Storage
When not use, the tool should be stored and transported in the
plastic case, to prevent damage.
Plastic case: size 445x290x95 mm; (17.5x11.4x3.7 in.) weight
1,2 kg (2.65 lbs).
The case can also hold up to 20 die sets.
3.3) Head rotation
For ease of operation, the tool head can rotate through 180°.
Do not attempt to turn the head if the hydraulic circuit is pressurised
3. WARNING
.
4