Key Definitions; Assemble Fountain - Petsafe Drinkwell SEDONA-PG-CA-17 Manuel D'utilisation

.

Key Definitions

Bowl: The plastic Bowl is the foundation of the Pet Fountain. The bottom of the Bowl
features four indentations to run the electrical power cord through.
Tower: Water is pumped up through the ceramic Tower to cycle through the Charcoal
Filter and out the top to create a waterfall into the Bowl.
Filter Housing: The plastic Filter Housing consists of a lid and base that holds the
Charcoal Filter.
Rubber Grommet: The Rubber Grommet comes already installed in the top of the
ceramic Tower and forms a seal between the Filter Housing and the Tower.
Rubber Cap: This rubber seal secures the electrical power cord to the inside of the
Bowl and prevents leaking.
Charcoal Filter: The 3-layer filter is made with granulated carbon derived from
coconut shells. The Charcoal Filter absorbs bad tastes and odours as the water passes
through and helps keep the water tasting fresh and more appealing to pets.
Foam Filter: The Foam Filter collects any hair, debris, and pet food before they reach
the Pump. It is important to use the Foam Filter as it helps maintain proper Pump function.
Pump: The small aquarium Pump can be partially dismantled for cleaning. THE PUMP
IS NOT DISHWASHER SAFE! Remove Pump from the Pet Fountain before cleaning
(see "Pump Maintenance" section for detailed instructions). The Pump also features a
removable in-line plug for easy attachment and removal.

Assemble Fountain

Important: DO NOT RUN DRY – FOR INDOOR USE ONLY. Monitior your Pet
Fountain periodically for the first 12 hours to make sure it is running properly.
Note: Rinse all fountain parts with warm water before operating the pet fountain. This
will remove any dust or residue that remain in the system from the manufacturing process.
1. Carefully remove all the Pet Fountain components from the packaging and set aside
prior to assembly.
2. As with any electrical device, check the electrical
power cord for any tears or damage before use.
3. Place the Foam Filter around the Pump by inserting
the Pump into the Foam Filter from the top. Make
sure the electrical power cord rests on top of the
Foam Filter (Fig. 1).
6
• Do not pull on the electrical power cord to remove the plug
from the wall outlet.
• To unplug, grasp the plug, not the electrical power cord.
www.petsafe.net
Fig. 1
Electrical
power
cord rests
on top