Petsafe Drinkwell SEDONA-PG-CA-17 Manuel D'utilisation page 7

.
4. Position the bowl so that the raised post should be to the right of the
square indention (Fig. 2). Place the Pump inside the square indention so the Pump
outflow, the circular opening on the top of the Pump, is positioned in the bottom left
corner of the square (Fig. 3).
5. Press down on the Pump to engage the suction
cups. Once the Pump is securely in place, feed the
in-line plug of the electrical power cord over and
through the raised post and out the notch on the
base of the Bowl (Fig. 4). There are four notches
to choose from.
6. Remove the extra slack from the electrical power
cord and insert the Rubber Cap into the raised
post. Make sure the cord channel on the Rubber
Cap is aligned with the electrical power cord, then
insert your finger into the Rubber Cap and push all
the way down (Fig. 5).
7. Fold the top of the Rubber Cap over the raised
post to seal off the Bowl (Fig. 6).
8. Rinse the Charcoal Filter thoroughly under cool
water before placing it into the Filter Housing. This
will remove any loose charcoal dust, which is
harmless. A small amount of charcoal dust may be
released for the life of the filter. This is normal and
is not harmful to your pet.
Fig. 5
www.petsafe.net
Fig. 2
Fig. 3
Fig. 4
Fig. 6
7