Jaga LINEA PLUS HYBRID ACO Manuel D'installation Et D'utilisation page 43

Snelheid 1

– Permanently off: All functions are disabled until the user switches on the unit via the control panel. Hold down [Mode]

MODE

until all LEDs are off.

10 sec

MODE

10 sec

3.1. NOTIFICATIONS

Blue LEDs are flashing: the water temperature for cooling is too high

Red LEDs are flashing: the water temperature for heating is too low

Control panel error codes

LED flashes rapidly in the color of the set mode.

MODE

The LEDs are blinking in a pattern and in the color that matches the selected mode

Only if the window contact is connecrted and switched on: The window contact is open.

MODE

4. SETTINGS

4.1. ADJUSTING THE WATER TEMPERATURE

Adjusting the maximum water temperature for cooling

By reducing the water temperature setting, the

unit will start later. If the water temperature is

set higher, the unit will start sooner.

1. Put the device in the cooling mode

2. Hold down the [Mode] and [+] simultaneously until the last 4 LEDs start flashing.

JAGA N.V. | LINEA PLUS HYBRID - ACO/B | MANUEL | 2024.09.12 | V.1.02

Snelheid 2

MODE

Check the water temperature sensor

Check the room temperature sensor

MODE

Adjusting the minimum water temperature for heating

By increasing the water temperature setting,

the unit will start later. If the water temperature

is set lower, the unit will start sooner.

necessary to reduce the water temperature.

1. Put the device in heating mode

MODE

15 sec

Snelheid 3

MODE

In combination with a heat pump, it may be

MODE