Publicité
6.3
FRONT SURROUND INSTALLATION
Secure the front surround brackets using 6 screws. Ensure to drill the brackets into the wall studs, see Figure 1.
NOTE: The 39" (991mm) is measured between the bottom of the appliance and the center of the middle
hole of the mounting bracket.
Install the front surround. Lift the surround up and slide onto the brackets until secure, see Figure 2.
Secure the bottom of the surround with 2 screws, see Figure 3.
6.2
GLASS DOOR REMOVAL / INSTALLATION
Before the glass door can be removed, the surround
with safety screen must be removed, see "SAFETY
SCREEN REMOVAL / INSTALLATION" section.
The glass door is secured to the top front edge of the
appliance with two latches. Pull the handles of the
latches forward, then lift the latches out from the door
frame to release the top of the door. Next, pivot the
door forward until the top edge clears the front of the
appliance. Carefully grip the sides of the door lifting it
out from the retainer along the bottom of the door.
NOTE: These latches make up the spring relief
system for the appliance. Ensure they open freely
and close sealed.
Reverse these instructions to reinstall the door and
surround with safety screen. Ensure the surround with
safety screen is installed correctly.
All manuals and user guides at all-guides.com
FIG. 2
FIG. 1
" A "
3 9 " (9 9
1 m m )
FIG. 3
HANDLES
W415-1347 / A / 03.19.15
35
EN
Publicité
