Publicité
Initial operation
Fitting/changing the saw blade
Always pull out the plug from the mains before
changing the saw blade
1. Set the cutting depth (using the locking screw
to the minimum position, 0 mm.
2. Swing the blade guard
GB
lever
and put the device down.
3. Press the spindle lock button
and use the Allen key
screw/washer
screw/washer
(see also Fig. A).
Fig. A: Changing the saw blade
4. Remove
saw blade.
5. Fitting a saw blade
reverse order.
6. Press the spindle lock button
and use the Allen key
screw/washer
WARNING!
►
The arrow on the saw blade
spond to the arrow showing the direction of
rotation (running direction shown on the
device).
■
Ensure that the saw blade
rotational speed of the tool.
32
!
back using the release
(until it engages)
to release the clamping
. Now remover the clamping
and the clamping fl ange
is carried out in the
(until it engages)
to tighten the clamping
.
must corre-
is suitable for the
Mounting/setting the guide fence
♦
Loosen the wing screw
fence
into the guide fence slot
♦
Set the desired cut width with the help of the
scale on the guide fence
)
arrow in the base plate
Fig. B: Cutting width 3 cm
♦
Retighten the wing screw
Connecting the sawdust extraction
appliance
♦
Attach the adapter for dust extraction
chip ejector
.
♦
Connect an approved dust and chip extraction
device.
Operation
Switching on and off
Switching on:
♦
Push the safety lock-out
and keep it pressed.
♦
Press the ON/OFF switch
running you can release the safety lock-out
Switching off :
♦
Release the ON/OFF switch
Setting the cutting angle
You can select the cutting angle with the help of the
cutting angle scale
■
Release the wing screw on the cutting angle
preselector
, set the desired angle on the
cutting angle scale
wing screw.
and insert the guide
.
and the marking
(see also Fig. B).
45
45
0
.
to the
to the left or right
. Once the saw is
.
.
and then re-tighten the
PHKS 1350 A1
.
Publicité
