Publicité
11 After Finishing Work
► Set target pressure with pushbuttons - and
+ (6, 9).
► To change the set speed: Hold pushbuttons
- and + (6, 9).
► Press the pushbutton
The compressor starts and tries to set the tar‐
get pressure on the product to be pumped up.
The compressor switches off upon reaching
the target pressure.
NOTICE
■ If no pressure is applied, the compressor auto‐
matically switches off after 5 minutes.
► Check the product to be pumped up, valves
and hose connection for pressures losses.
► Switch the compressor on again.
Blowing and suction mode
► Remove pressure hose on the underside of
the compressor.
10
12
► Insert pressure hose (12) to the hose connec‐
tion (10) for blowing mode or to the hose con‐
nection (11) for suction mode.
► Insert pressure hose (12) into the valve of the
product to be pumped up or down.
► Press pushbutton MODE (7) and select the
blowing or suction mode
► Press pushbutton
The compressor starts the blowing and suction
mode.
► If the desired pressure in the product is
reached: Press pushbutton
The compressor switches off.
10.2
Switching on the lamp
► Switch on the compressor.
► Press the pushbutton
11 After Finishing Work
11.1
After finishing work
► Switch off the compressor and remove the
battery.
0458-057-9601-A
(5).
11
12
.
(5).
(5) again.
.
► If the compressor is wet: Allow the compressor
to dry.
► If the battery is moist or wet: Allow the battery
to dry,
17.6.
► Clean the compressor.
► Clean the battery.
► If the compressor, battery or charger is hot:
Allow the compressor, battery or charger to
cool down.
12 Transporting
12.1
Transporting the compressor
► Switch off the compressor and remove the
battery.
Carrying the compressor
► Carry the compressor by the handle (1) with
one hand.
Transporting the compressor in a vehicle
► Transport the compressor with the packaging
supplied.
► Secure the packaging so that it cannot move.
12.2
Transporting the battery
► Switch off the compressor and remove the
battery.
► Check that the battery is in a safe condition.
► Transport the battery with the packaging sup‐
plied.
► Secure the packaging so that it cannot move.
The battery is subject to the Carriage of Danger‐
ous Goods regulations. The battery is classified
as UN 3480 (lithium ion batteries) and has been
tested pursuant to UN Manual Tests and Criteria
Part III, Subsection 38.3.
The transport regulations can be found at
www.stihl.com/safety-data-sheets.
12.3
Transporting the charger
► Disconnect the mains plug from the socket.
► Remove the battery.
► Wind up the connecting cable and attach it to
the charger.
English
1
31
Publicité
