Publicité
English
► Hang the charger on the wall mounting.
4.12
Cleaning, maintenance and
repair
WARNING
■ The compressor may start up unintentionally if
the battery is left in place during cleaning,
maintenance or repair operations. This may
result in serious injury to people and damage
to property.
► Switch off the compressor.
► Remove the battery.
■ Harsh cleaning agents, cleaning with a water
jet or pointed objects can damage the com‐
pressor, the battery and the charger. If the
compressor, the battery or the charger is not
cleaned correctly, components may no longer
function properly or safety devices may be
rendered inoperative. People may suffer seri‐
ous injuries as a result.
► Clean the compressor, battery and charger
as described in this User Manual.
■ If the compressor, battery or charger are not
serviced or repaired correctly, components
may no longer function properly, or safety
devices may be rendered inoperative. Persons
may be seriously injured or killed.
► Do not attempt to service or repair the com‐
pressor, battery or charger.
► If the compressor, battery or the charger
require servicing or repairs: Contact a
STIHL authorized dealer for assistance.
5
Preparing the compressor
for operation
5.1
Preparing the compressor for
operation
The following steps must be performed before
commencing work:
► Ensure that the following components are in a
safe condition:
– Compressor and high-pressure hose,
4.6.1.
– Battery,
4.6.2.
– Charger,
4.6.3.
► Check the battery,
► Fully charge the battery,
► Clean compressor,
► Check the controls,
28
9.2.
6.2.
14.1.
9.1.
5 Preparing the compressor for operation
► If you cannot carry out these steps: Do not use
the compressor and contact a STIHL author‐
ized dealer instead.
6
Charging the Battery, LEDs
6.1
Mounting the charger on a wall
The charger can be mounted on a wall.
1
2
a
b
a
► Check the following points when mounting the
charger on a wall:
– Use suitable mounting materials.
– The charger is level.
The following dimensions are observed:
– a = at least 100 mm
– b = 54 mm
– c = 4.5 mm
– d = 9 mm
– e = 2.5 mm
6.2
Charging the Battery
The charging time depends on various factors,
e.g. the battery temperature or the ambient tem‐
perature. For optimum performance, note the
recommended temperature ranges,
actual charging time may vary from the charging
time indicated. The charging time is indicated at
www.stihl.com/charging-times.
The charging process starts automatically when
the mains plug is plugged into a socket and the
battery is inserted into the charger. The charger
switches off automatically when the battery is
fully charged.
The battery and the charger warm up during
charging.
1
3
3
d
e
e
17.6. The
2
5
6
4
0458-057-9601-A
Publicité
