Publicité
1
The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly,
1
2
3
4
Press one of the function
buttons to select a
source.
If TUNER/BAND is pressed, the band cannot be selected in
this step,
Press TIMER repeatedly until @ appears on the
display.
Time and audio source name flash alternately.
b
Within 6 seconds, turn MULTI JOG to designate
the timer-on time, then press ENTER or Il.
Turning MULTI JOG changes both the hour and the minute.
+
or -
is also available instead of MULTI JOG, Holding
these buttons down will vary the time rapidly.
Within 4 seconds, turn MULTI JOG to select the
duration for the timer-activated
period.
The duration can be set between 5 and 240 minutes in 5-
minute steps.
+
or -
is also available instead of MULTI JOG.
5
6
7
Adjust the volume.
E
The source sound will play at the volume level set in this step
.:
when the power is turned on by the timer.
If the volume level is set to 21 or higher, however, it will
,~
automatically be set to 20 when the power is turned on.
,4%:'
Prepare the source.
'%"
To listen to a CD, load the disc to be played first on tray 1.
'*,:
'g'
To listen to a tape, insert the tape into deck 1 or 2.
To listen to the radio, tune in to a station.
s
Press POWER to turn off the power.
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
m
You can change the source that was selected in step 1 by pressing
one of the function buttons before pressing ENTER or II in step
.
To check the timer setting
Press TIMER.
The selected source, the timer-on time, and the duration for the
timer-activated period will be displayed for 4 seconds.
To change any of the previous
setting
Carry out from step 1.
However, if you do not change the timer-on time, in step 3 just
press ENTER twice and continue from step 4.
To cancel the timer standby
mode temporarily
Press TIMER repeatedly so that@ disappears.
To restore the timer standby mode, press" again to display @.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, -carry out st;p 5 and 6.
m
Timer playback and timer recording will not begin unless the
power is turned off.
Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer,
Timer recording is applicable for TUNER and VIDEO/AUX (with
an external timer) sources only,
Press either TUNER/BAND
or VI DEO/AUX/5.l CH to select a
source, then press TIMER repeatedly
until @REC lights up
on the display.
Within 6 seconds, carry out the steps of
"SETTING THE TIMER" from step 3 and insert the tape to be
recorded on into deck 2 after step 6.
m
When the power-economizing mode (page 7) has been turned
on, the timer recording volume level will be O (minimum level).
You cannot use the timer function to record from a CD or tape.
The duration will be automatically set after 4 seconds. It will
also be set if ENTER or II is pressed within 4 seconds after
step 4.
ENGLISH
29
Publicité
