Publicité
MANUAL
SELECT
1
2
++
DOWN,
-UP
1 Press VIDEO/AUX/5.l
CH and start playback of
the video source.
'VIDEO" is displayed.
If "5.1 ch IN" is displayed, press VIDEO/AUX/5.l
CH again.
2 Press DOLBY PRO LOGIC.
"NORMA~
is selected, and the playback sound has the
DOLBY PRO LOGIC effect.
TCJcancel Dolby Pro Logic mode
Press DOLBY PRO LOGIC repeatedly
until "PRO-OFF"
is
displayed,
TCIchange the sound
levels during
playback
After adjusting the balance with the noise sequencer, the sound
levels of the center or each surround speaker can be adjusted
during playback of laser discs or video software.
1 Press MANUAL SELECT on the remote control repeatedly
to select "CEN" (center speaker) "S-L" (Left surround speaker)
or %-R (Right surround speaker).
2 While the "CEN''''S-~ or''S-R is displayed, press ~
DOWN
or -
UP on the remote control to adjust the volume.
ADDITIONAL
DOLBY PRO LOGIC MODES
:
In addition to the NORMAL mode, this unit is also equipped with
e
,+
the PHANTOM and the 3 STEREO modes.
@ ~
PHANTOM mode: Use this mode when no center speaker is
connected, The center channel signals are output through the
'E ':
left and right speakers.
*
3 STEREO mode: Use this mode when no surround speakers
g
are connected. This mode reproduces rear sounds through the
~
front speakers,
To select PHANTOM or 3 STEREO
Press DOLBY PRO LOGIC repeatedly until the desired DOLBY
PRO LOGIC mode is displayed, The DOLBY PRO LOGIC mode
is displayed cyclically as follows,
C::"=
To adjust the balance of connected
speaker sound levels
Carry out steps 2 to 4 of "ADJUSTING
SPEAKER
LEVEL
BALANCE",
m
Depending on the sound source and/or listening conditions, a
surround effect may not be obtained even when the DOLBY
PRO LOGIC
The full DOLBY PRO LOGIC effect cannot be obtained when
using software without
IIOIDOLBY SURROUNDI
mark, In this case, use
the SURROUND system instead. (See page 14.)
The DOLBY PRO LOGIC is automatically canceled when:
- the ECHO level is changed.
- the SURROUND system or the BBE is turned on,
- the headphones are plugged in.
- the Karaoke function is turned on.
- the 5,1 CH (page 31) is selected.
" Set the microphone volume to OFF while the DOLBY PRO
LOGIC is on. Otherwise, the DOLBY PRO LOGIC sound cannot
be reproduced correctly,
ENGLISH
25
Publicité
