Publicité
MUSIC SENSOR
If there is a 4-second or longer blank between each track, a search
for the beginning of the current or next track during playback can
be done easily.
Press <
or -
during playback referring to the playback side
indicator (4 or E) on the display.
For example, when -
is pressed while>
is displayed, playback
of the next track starts,
Music sensor function may not be able to detect tracks under the
following conditions:
Blanks of less than 4 seconds between tracks
Noisy blanks
Long passages of low-end sound
Low overall recording levels
Deck 1
1
After playback on one deck finishes, the tape in the other deck
will start to play without interruption.
1
2
3
4
Insert tapes into deck 1 and deck 2.
Press TAPE/DECK
1/2 to select the deck to be
played back first.
Press REV MODE (DECK 2) to select =1.
Press 4
to start playback.
Playback continues until
is pressed.
About cassette tapes
To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
Side A
\
Tab for side A
J
To record on the tape again, cover the tab openings with
adhesive tape, etc. (On Type
II
tapes, take care not to cover
the Type
II
tape detection slot.)
120-minute or longer tapes are extremely thin and easily
deformed or damaged, They are not recommended.
Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may break or jam in the mechanism.
ENGLISH 17
Publicité
