Publicité
1
2
Press TUNER/BAND
repeatedly
to select
the
desired band.
FM —
AM
r----1
When TUNER/BAND
is pressed while the power is off, the
power is turned on directly.
Press
W
DOWN
or M
UP to select
a station.
Each time the button is pressed, the frequency changes.
When a station is received, "TUNE" is displayed for 2 seconds.
During FM stereo reception, (IK3M}Iis displayed.
([lam)]
TUNE
To search for a station quickly (Auto Search)
Keep M< DOWN or ~
UP pressed until the frequency starts
to change rapidly. After tuning in to a station, the search stops.
To stop the Auto Search manually, press M
DOWN or FM
UP.
"TheAuto Search may not stop at stations with very weak signals.
When an FM stereo broadcast contains noise
Press MONO TUNER on the remote control so that "MONO"
appears on the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, repeat the above so that "MONO"
disappears.
TIOchange the AM tuning
interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press POWER while pressing <P.
To reset the interval, repeat this procedure.
When the AM tuning interval is changed, all preset stations are
cleared. The preset stations have to be,set again.
lfi
2
CLEAR
The unit can store a total of 32 preset stations. When a station is
stored, a preset number is assigned to the station. Use the preset
number to tune in to a preset station directly.
1 Press TUNER/BAND
to select a band, and press
H
DOWN or WI
UP to select a station.
3 Repeat steps 1 and 2.
The next station will not be stored if a total of 32 preset stations
for all the bands have already been stored.
m
"FULP' is displayed if you attempt to store more than 32 preset
stations.
Use the remote control to select the preset number directly.
1 Press TUNER/BAND
to select a band.
2 Press numbered buttons O-9 and +10 to select a
preset number.
Example:
To select preset number 20, press +10, +10 and O.
To select preset number 15, press +10 and 5.
Selecting a preset number on the main unit
Press TUNER/BAND
to select a band. Then, press +-
repeatedly or turn MULTI JOG.
Each time +>
is pressed, the next ascending
number is
selected.
To clear a preset station
Select the preset number of the station to be cleared. Then, press
W CLEAR, and press 11 SET within 4 seconds.
The preset numbers of all other stations in the band with higher
numbers are also decreased by one.
ENGLISH I 5
Publicité
