Publicité
WINTER:
The valve is open to relieve the pressure on the gaskets.
9.0 MAINTENANCE AND CARE INFORMATION
Always switch off the appliance and disconnect the power plug before carrying out maintenance
or inspection work.
Check all the parts for signs of wear. Do not continue to use the product if you find any defects.
Parts should only be replaced with original spare parts, and by a specialist, in accordance with the
manufacturer's specifications. A lack of care and maintenance can damage the appliance.
Dangerous situations can arise. Regular maintenance helps to ensure the safety of the product
and increases its service life.
CLEANING FILTER MEDIA
When the filter has been in use for some time, the impurities inside it cause the pressure to rise
and the flow rate to drop. In this case, you must clean or replace the filter balls (or the quartz
sand).
Filter balls:
Clean the filter balls with a garden hose or wash them in water several times to remove fine debris.
Before cleaning the filter balls, they can be left to soak in cleaning agent for a while.
Quartz sand:
Clean the quartz sand with water at low speed until the surface of the quartz sand is free of dirt.
Otherwise, you can pour the quartz sand mixed with water into a sieve to screen out the impurities.
It is important to note: Quartz sand is a consumable material, please replace the quartz sand if
necessary.
WINTER STORAGE AND LONGER-TERM STORAGE
• Clean the kit before storage.
• Store the kit in a dry and frost-proof area, out of the reach of children.
• If you intend to store the pump for an extended period of time, you must clean the appliance
thoroughly after the last operating session and before using it again. Otherwise, start-up
difficulties may occur due to residues or deposits.
• All other work, especially opening the pump, should only be carried out by a qualified
electrician.
10.0 TROUBLESHOOTING
Problem
Pump
with
no
action
Pump
works
audibly,
but
no
water is flowing
Possible cause
No power available
Air in system (pump/tank)
Hoses are kinked, pump is
taking in air
Suction
height
too
incorrect suction hose
Solution
Insert plug or check fuses if
necessary
Ventilate the pump as described
and if necessary also the tank.
Check and, if necessary, correct
and seal straightened connections.
Possible hose leak
high,
Adjust the position of the pump.
Use vacuum-safe suction hose
25
www.DEUBAXXL.de
Publicité
