Publicité
5.0 PARTS LIST (graphic on page 2)
Valve head (7-way valve)
Sealing plug
Sealing flange
O-ring
Riser pipe
Filter tank
Drainage nozzle
O-ring
Connection adapter
Hose clamp
Hose 1 1/4" (32 mm) x
35 cm
6.0 PLACEMENT OF THE UNIT
NOTE: The pump is not self-priming.
Place the sand filter system (empty of filter media) close to the pool. IMPORTANT: the system must
be located far enough from the pool so that splash water cannot damage the pump or cause
flooding.
Installation and set-up must be performed in accordance with local regulations, according to the
rules of your pool and the local conditions.
The system must also be placed on a secure, stable surface! The filled filter tank becomes very
heavy and must not tip over, e.g. due to collapsing ground, nor cause any damage to your floor.
Take into account the connections to be made later, e.g. water and pump power, when positioning
the sand filter system.
Ensure that the instruction label is still visible on the filter tank and pump in case any questions or
issues arise later.
INFORMATION
• If the pump is placed above the water level, a backflow valve must be installed in the system.
• If the pump is positioned below the water level, it is important for maintenance purposes to
ensure that the water supply to the pump is interrupted, otherwise the water may run out of
the pool unhindered.
• Hoses and connections should be kept as short as possible and without any kinks. This reduces
the flow capacity, meaning your system would suffer loss of performance.
• Make sure that the connection rings, hose clamps and all sealing rings are properly positioned.
NO.
QTY
1
1
2
1
3
1
4
1
5
1
6
1
7
1
8
3
9
3
10
2
11
1
21
Sealing
plug
O-ring 1 1/2" MIP
Pressure gauge
Filling funnel
O-ring
O-ring
Connection adapter G1
Seal
Pump 100 W
Base
Filter medium
(without illustration)
Teflon tape
(without illustration)
NO.
QTY
with
12
1
13
1
14
1
15
2
16
2
17
2
18
2
19
1
20
1
21
1
22
1
www.DEUBAXXL.de
Publicité
