Eaton Tripp Lite Serie Mode D'emploi page 17

NOTE
To temporarily mute the alarm while the unit is in battery mode, press and hold the
icon flashes on the LCD screen to indicate that the alarm has been temporarily muted.
NOTE
2 2 . . 1 1 3 3 S S e e l l f f - - T T e e s s t t
Press and hold the
UPS switches to battery. Upon completion of the test, UPS will return to line mode. If test fails, the display will
indicate the
self-test. If there is another failure, contact Tripp Lite for battery replacement options. Connected equipment
can remain on during the test. Do not unplug your UPS; this will remove safe electrical grounding.
2 2 . . 1 1 4 4 E E r r r r o o r r M M e e s s s s a a g g e e s s
The UPS reports BATTERY REPLACEMENT and OVERLOAD STATUS using the
In the event that the UPS battery requires replacement, the
icon will light. Replace the UPS battery to reset the
replace-battery indicator.
Figure 8. Replace Battery LCD Screen
2 2 . . 1 1 5 5 C C r r i i t t i i c c a a l l F F a a u u l l t t S S c c r r e e e e n n s s
More severe fault conditions will result in the UPS shutting off power to the UPS-supported output receptacles.
At this point, the LCD screen will report any one of 5 possible on-screen fault codes. Some faults, such as
Silent mode can only be selected while the unit is in online mode. Silent mode will
deactivate the beeper completely.
The low battery alarm will still sound even if the battery alarm is temporarily muted.
TEST
button to initiate the UPS self-test. The test will last approximately 10 seconds as the
icon and an alarm will sound. If this occurs, charge the batteries for 12 hours and repeat the
Eaton Tripp Lite Series Cloud-Connected UPS Systems User Guide 9349D0—Rev A
If there is an overload, the
the LCD screen will report the output load percentage.
Self-Test
button until the
and the icons.
and % icons will light and
11